Sample Output from the VTScada WAP Application

If you were to connect to your VTScada application using the following steps:

1.   Enable VTS/IS

2.   Configure a realm that is WAP-enabled and that links to your application

3.   Connect to your application via a WAP browser

Then, you would see screens similar to the following series:

 

Welcome screen.  Visible only for a few seconds

 

Main Menu.  Select Station List for the next screen.

 

Result of clicking on Station List. Shows all polling drivers.

Click on a polling driver to see the I/O attached to it.

 

I/O tags attached to the selecting polling driver. 

Click on Analog Control to see I/O tags of that type that are attached to this driver.

 

Analog Control tags attached to the selected polling driver.

Click on one to send a new control value.

Allows a new analog value to be set.