Apply the new skills you've learned so far in this lesson to attach all of the equipment on the Booster Station application page (as per our P&ID) using the Pipe tool. Use Figure 76 as a reference for the pipe locations.
• The discharge of the booster pump should be attached to the intake of the booster tank (use dark blue pipe 3 pixels in width);
• The booster tank should be attached to the compressor (use light blue pipe 3 pixels in width); and
• The discharge of the booster tank should be attached to the water main (use dark blue pipe 5 pixels in width).
Remember to use the Send To Back button to ensure that each pipe you draw is moved to the back layer.
If you need assistance in finishing this section, please refer to the instructions in Solution for 6.2 On Your Own Section.